Hey guys: Getting close to the holiday season, figured I'd mod my core P5 case once again xD. While my last build featured a display underneath...
I would like to see you Hardline the back of the case as well, since you've done such an awesome job on the cables, you should make the tubes to...
Haven't tried printing the thread as I worry slight discrepancy may exist and the screw wontw fit/ too loose. Considering the material cost if...
And btw, the measuring temperature at the left side of the rad unit is about 5-6 hotter than the right. So coolant is already mostly cooled down...
Some stress test results: All temperature measured with an infrared thermometer. The loop is configured in the following order, CPU -> GPU ->...
The build is complete: [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH]
Honestly, those 3d printed parts looks way too good coming out from a fdm printer. Did you sand all the parts before painting? If so I can imagine...
Its printed with resin from a dlp 3d printer. Dlp 3d printing is known for its high accuracy, but material cost is about 4x conpared to...
Not too sure if this works with resin, resin's melting temperature is a lot higher than PLA, so heating it to push the insert in might be...
[ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH]
For all those saying stacked rads are inefficient and blah blah... I agree it would be better to have all 4 receiving fresh air intake, but design...
These rads and normal PC rads aren't the same. These are designed with low fin density for higher air flow, so even if 2 are stacked on top of...
They are not connected rather, the radiator is placed inside the casing. Since all dimensions have veen measured, the design ensures minimal gaps...
Radiator cases painted.[ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH]
Separate names with a comma.
