Well what can one say but, u rock Zap, I can only hope but have the access to the tools u have and have the skills to do workmanship like...
what ca i say but.......wow :jawdrop:
Thx for that was also thinking of using some sort of epoxy for the coating to totally encase the mobo..... Will sort something out :rock:
Thats ok i live off fast food anyway....lol Well this is the remains of the parts removede from the board [IMG][/IMG] And my optical mouse...
Motherboard as mouse mat (Update) Well all the components are off...bit of wet and dry to get rid of the remaining solder then a brilo pad to...
looking good....shame about the finger, bet that stings a little Keep it up.... :D
That 3d image trick is so cool...took me a while to see it....when i did my eyes screwed up and it took me 10 mins to stop them crossing......the...
U wait for wot seems to be an eternity and then some comes up with a cool mod.....and i must say this is cool.....i want one......me personally...
Barit.....you could have the roller door material removable from the top...this would solve the problem with radius being too sharp....Great idea...
Once the mesh is cleaned up should look cool....hope the front does look as if it is one piece.... :D
Personally id go for the compressed air option.....wouldnt trust a vacuum cleaner on blow because of the possible static that may be...
Couldnt believe the components just fall off when u put it over the cooker ring......heat it up and one small tap and u got a pile of components...
I once used a butter knife and half a brick to take a Honda C90 engine apart.....had no tools at the time It never worked again...... :wallbash:
suppose a pic of the case wud help ppl give u ideas.....no bad vibe intended :idea:
[IMG] Almost there....just a few surface mount components to remove then going to try a brillo pad on the board to try and make the traces more...
Separate names with a comma.
