He he, the applying twice bit back today. I got assigned two separate guys, so had the guilt ridden job of letting one of them down.
I signed up on Sunday, yet haven't had a contact from Coolermaster yet. Is it still open to applications? I had a confirmation that they...
Update September 8th well hello all again, it's been a while. I have just spent the last 7 weeks in Austrailia which took a little longer to...
Hi all, sorry for the late posting of this update. I really wanted to get some more material into it before putting it up. Its been a strange...
Mini Update 26th June Thanks for the great comments I'm also glad its not just my jaw thats hit the ground about how big this project is....
Update June 24th Well I have been busy working for this update, slogging through the rear section and finalising a few odds and ends. Since my...
Update 12th June Hey I know it hasnt been that long since my last update but I have been on a mission. I wanted to get the mainbody done and...
Update 10th June Well I have been quite busy filing for this update, Started off with some nice gluing. I had to sand down just above the pci...
Update 1st of June Its been a while since I last updated, I've had a lot on my plate lately along with the hayfever season. But here it is. Had...
I dont think a dremel would really be strong enough but a good wood router with the right attachment and enough cooling fluid going around it...
Well I can do within limits, but email me with some details and I will see what I can do.
It is thanks, Im trying to think where i am going to put it afterwards. All my desks are too small. He he I am marking out the holes for the...
Well you are going to need a momentary 2 pole switch. So you flick/press it then it goes back to its original position.
I use a 1/8" sprial upcut bits [IMG]
Solved some how? I have no idea how but I tried again after 3 attempts over the weekend and it just worked
Separate names with a comma.