Ribbon cable is probably not a bad idea. Unfortunately, the leads don't go through to the other side of the board. I'm not sure on the spacing....
I've got a bunch of these nice bare CCDs that I'm using for various things. One thing that is a huge PITA, is trying to enable certain features...
I'm retarded, you answered my question in the first post, probably shouldn't reply first thing waking up :lol:
So does positive ground mean it's not grounded through the body or that it is? Makes me think of dad's old Crown Victoria. Had a couple of...
I'll be honest, the whole discussion of positive ground has always confused me :) I'm not adding any grounds or even cutting any wires though...
Thanks for the suggestions. In addition to the ground potential, I still need to measure the current draw through the #5 switches, considering...
I've got a question on grounds as a follow up on my relay questions. Please bear with me if this is meandering. Basically, I'm replacing my car...
Driving the motor directly is out as I'm trying to integrate it into the factory harness. There's an RC network inside the motor itself and...
If I may ask one more probably silly question for the sake of my curiosity. Seeing I'm going to be using these as SPST switches, figured it...
Well you could use ones that have have six-leads, something like these
Perfect, Is there anything electronics you don't know? :)
You are the man. Many thanks as always, just the info I was looking for. One more question if I may, I'm trying to avoid cutting up the...
Still working on my car pc project and finally starting on the pic based digital HVAC replacement. I need to replace the blower switch and work...
Separate names with a comma.