Hi all, sorry I havn't been on for a while, but the truth is I've been working offshore for the past couple of weeks. I did manage to start on...
Update UPDATE To keep the radiator fins in contact with the tubes, and to keep the fins equidistant, and parralell; I cut 4mm spacers out of...
Sorry for long overdue update UPDATE Sorry that I havnt been updating my progress rugularly, its just been long tedious repetitive jobs. I...
Got all the copper and bits and pieces today, so will start working on the radiator tomorrow.
microscopical extrusions ?? Lol I asked about this earlier,:read: and Cause i read this article...
Manifold, flow valves & flow meters Should be getting all the parts 2moro, had to phone around to see what lenghts they were sold in, then add...
I get what your saying, It would increase flow, but connectong the caps will be difficult cause they staggered and not inline. What if I used two...
But then I wont be able to fit the pipes so closely on the radiator, and my radiator has 40 passes, so if I put 40 90 degree or " L" shape elbows...
You'll have to excuse my drawings, I prefer a pencil, compass and ruler to Autocad.
The copper plate will be 2mm thick, with a 2mm gap between each one. The copper tube will stick out 10mm on either side of the plate, so that...
[IMG]
UPDATE: Went hunting for the best copper prices. Its quite hard to buy a section of copper sheet! Found some nice brass garden hose connectors...
Sorry, done.:thumb:
Hi all I've had an old perspex Gigabyte case that i've been slowly modding over the past couple of years. I read turpija's mod quite a while...
Starting my own homemade mod Hi all I've had an old perspex Gigabyte case that i've been slowly modding over the past couple of years. I read...
Separate names with a comma.