It can now fit the res you made me in it :). Ill do a video once were finished of the whole place..... were getting racking put in next week for...
UK North East and proud manufacturer Of PC Liquid Cooling.. [MEDIA] Mayhems Manufacturing of Corsair coolants (bottling side). As of today it's...
Well today they posted all about there "Pastel Coolant". seems like they are just infringing and don't care. Some thing is happening at our end...
Without Prejudice What we have offered them is this - 1) Remove our registered trademark. 2) They can use the registered trademark but must...
You are right the PI 3 only need a small flat heat sink and can be overclocked with no issues even on water cooling.
https://www.youtube.com/watch?v=aBxdSw4Rwwk The XU 4 and Water cooling unit (corsair) Inc the 120mm Fan are powered from a single 12v 5 amp...
Yes the underneath is cooled from the air flow from the AIO from the back and then is vented out the side so it doesn't create noise. Temp...
A heat sink and fan do not get the temps down and do not stop it from throttling. This has been tested over and over again and is the major "flaw"...
We all Love gimmicks but when your gimmicks trun out to be the near perfect cooling solution for a small system such as the Odriod XU4 from...
Yeh i need to do some Manuel shots once i get some back ground for it. Its a very clean looking build Matt done a good job on some of the work hes...
[IMG] [IMG] [IMG] [IMG] [IMG] Just some quick shots. Major question asked does it cool better than water? ...... Yes it does 1c above...
A quick bad pic of the progress so far -> [IMG] Were not happy with the long peace of glass fitted and will be changing it over to straight...
[IMG] Nearly done just a few more tweaks need doing. Had to remove one of the glass bends as we found out that the CPU / GPU ports are 2mm out...
Yeh we use a pro to help us out with the tubing. He has some amazing skills when it comes to glass bending. Ill look up that Dichoric glass....
Our glass is a pyrex brand and is hand blown into place and then re hardend in a kiln at 1700c . All the peaces at with in a 0.02mm -/+ spec. Im...
All our glass tubing is hand made. http://mayhems.co.uk/store/tubing/hard-tube/
Well a small accident happend we saw that the front panel was out by approx 2 mm so tried adjust it, in the process we bent it and its...
yeh you missed it lol. Edited too keep the peace lol
@xivlia Unlike like plastic tubes were using glass so less issues, Topping up is easy i have 5 ltrs of the stuff made all ready to go :), that...
[IMG]
Separate names with a comma.