Hi, Im at the starge of building a new system and want to know whats the best memory to go for. I am going to use an AMD FX55 processor and the...
Thats a good question. Im just sorting out what things im going to get and where im going to get them from. The guy doing the RAD mounting will...
Yep. Thats what i will do risky. When i test the system, i will drain it by tilting the case on its front then removing the lid on the RES and if...
Ok, so i just got to make sure that eveythings is held/screwed properly in and nothing moves in the case. Then i will have no problems in draining...
Then thats the way i will drain the system. Now i dont need the T-Junction or the fillport. As long as the system is running without any leak...
Nexxo thanks for the help. I can use the fillport but it is a matter of space. I am sort of running out of space in the case. If worst comes to...
Thanks for the help risky. I think i may go for the way you and nexxo say with the T-Junction but still just thinking of how it can be done.
Nexxo do you mean that fillport dangerden sell? or if not, can you please post me a link? Also wont this T-Junction affect flow? Nexxo if you...
Hi, Wouldnt there be no easier way like without adding shut of vales Etcc.? Something like tilting the case on its front, then opening the...
Yep. I shall order M3 Rods (They come in 1m Lengths) and will order some nuts and washers and grommets as well. And thanks for your help on how...
Hi. I found this website: http://www.greenweld.co.uk/acatalog/Shop_Rods_63.html that sells M3 200mm long Rods. Can you tell me if these will...
Hi. I have usually used IDE HDD's in my computer and i wish to change to SATA. I basically need some info on these things like how to connect...
Hi. Would there be any thinner diameter screws/Rods where i dont have to drill the Rad hole's? If this is the only option by drilling then it...
Yes i do. But if anyone knows or have ordered these from a website, if they can please tell me. But i will go to B&Q Tomorow.
Yeh the fans will pull air through the RAD (look at setup on previous page). And im not sure yet how many PCI slot i will use up but i will tell...
ok the BIX3 will fit without any cutting to the 5 1/4" cage hopefull becuase the width of the RAD is 5.25". As for the motherboard this should...
Hi, Thanks for that. I will check the pump to see if it fits and as for RAM i am going to go for the Corsair Po moduals so i will keep in mind...
Sorry Risky but if you can just tell me what you mean by that. I get that the RAM wont be a issue signal and interfernace wise with the pump, but...
Well i emailed the person doing the mod for the BIX3 and he said that he still hasnt had time to check on it but will get back to me as soon as...
I think i will just order the HoseLocks for the BIX3 and Pump. Will this be fine as the barbs are far apart on them leaving enough space for the...
Separate names with a comma.