The build is finally all complete. Will upload finall photos soon. Still need to finalize my Aida64 Sensor panel layout, but everything works...
Made my own cables: 1. USB micro to internal usb (couldnt find one to buy that would fit they way I need) 2. HDMI cable 3. Plug for connecting PC...
Used bondo to fill and smooth out all the 3d printed pieces. Primed all the new aluminum pieces and 3d printed pieces. Then installed all the...
Got a lot of work done, will update the log very soon. Finished milling the distro plate. [IMG] [IMG] [IMG] [IMG] [IMG] [IMG] Installed the EK...
Finally done with all the aluminum work. Just the distro is left and paint. PSU cover out of aluminum and wire cover with integrated wire clamps...
Thank you. Whatever helps and prevents mistakes.
Making some progress... Milled the GPU support bracket with back panel. [IMG] [IMG] Installed a different GPU that I have lying around to make...
Adivce is always welcome. I would like to say I know what Im doing with the CNC, but still learning, had a few Ooops moments where I broke bits...
I don't mean to sound like I'm complaining, I was just expecting a little better finish. Alex from bit tech recommended to me the polished end...
I'll see how the polishing without flame treating works, I have done it once, and it wasn't bad. I was also expecting better results with that PCD...
Printed and installed the back panel cover. [IMG] [IMG] The panel holding the corsair Commander Core XT and RGB Node, interlocks into the large...
Thank you, there were a lot of changes and I still keep tweaking it as I get more ideas. Right now I have to integrate a molex female plug into...
Not much progress, just a few design changes. I will start 3D printing the back panel cover today, but i had to change the design. I made the...
Progress... Did some 3D printing. Worked on the status monitor enclosure with the top cover with integrated power switch and part of the PSU...
Thank you!
Thank you!!
Thank you for the heads up. It's interesting because when I created the thread and even this morning when I checked on it after it was released...
Hello all, first time posting on here! I’m finally ready to start my next case mod, this time for my own personal use. It took a few months to...
Separate names with a comma.