Hi just got this board, all works fine including overclocking etc. (it’s even stable!,however it's not latest revision 1.02g ) Have connected a belkin powered usb hub where my webcam and headphones connect into. Comes up as generic usb hub in device manager and all is well. When I switch computer off for a while and the start up, usb hub does not get recognised in windows and webcam and headphones don't work.(no green lights on the hub) Take the usb lead out of the usb port and plug it back in then after a couple of times it will find it again,when I do a restart this problem does not occur. Setting in Bios in USB configuration: legacy USB support enabled Plug and play O/S enabled Latest bios E6400 2 gig ram xp Any ideas? Thanks.