1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Hardware BitFenix Pandora ATX Review

Discussion in 'Article Discussion' started by Dogbert666, 30 Nov 2015.

  1. Dogbert666

    Dogbert666 *Fewer Lover of bit-tech Administrator

    Joined:
    17 Jan 2010
    Posts:
    1,678
    Likes Received:
    181
  2. nimbu

    nimbu Modder

    Joined:
    28 Nov 2002
    Posts:
    2,510
    Likes Received:
    243
    I sent back the MATX version because the Panel edges and the rear alu extrusions were razor sharp. Was confident that the dog was going to slice his nose off on it.

    How did the review sample fair on that one?
     
  3. Otis1337

    Otis1337 aka - Ripp3r

    Joined:
    28 Nov 2007
    Posts:
    4,701
    Likes Received:
    204
    expect more for £100 really. the plastic front panel is a big turn off
     
  4. Guest-56605

    Guest-56605 Guest

    Quote "This also means that the roof section is limited to half-height radiators and a single row of fans".

    To be fair this isn't a biggy IMO (hands on experience also) as you only gain around a 20% performance gain at best (push/pull config) along with the cost of additional fans (potentially the additional noise also), secondly push or pull in a single bank of fans config - performance wise is the same.

    Quote "The case doesn't really have a Phanteks level of pizazz in terms of looks".

    Again I'd have to question this statement as to be fair some of the Phanteks offerings are butt ugly (cheap looking) and have what are fast becoming surplus to requirements 5 and a quarter bays.
     
Tags: Add Tags

Share This Page