Folks, I'm a bit of a noob when it comes to overclocking, so i'd like a bit of advice.... I'm currently trying to overclock my e7300 - this hasn't been too much of an issue as I've managed to get 3.4ghz out of it and it's been stable. However, i've just finished my mod on a g5 case, and fitted everything in. So I thought that i'd try and push the cpu a bit more - say to around 3.6-3.8... however, it just won't run stably and keeps crashing after around 10 mins.... Here's what I've done so far: Ai Overclock Tuner : Manual CPU Ratio Setting : 9.0 FSB Frequency : 395 PCIE Frequency: 105 FSB Strap to North Bridge : Auto DRAM Frequency: ddr2-791 DRAM Timing Control: 4-4-4-15 DRAM Static Read Control: Auto Dram Read Training : Auto MEM OC Charger : Auto Ai Clock Twister : Auto Ai Transaction Booster : Auto CPU Voltage : 1.37500 CPU GTL Reference: Auto CPU PLL Voltage : 1.54 FSB Termination Voltage: 1.38 DRAM Voltage : 2.10 NB Voltage : Auto PCIE Sata Voltage: Auto Load Line Calabration : Enabled CPU Sread Spectrum : Disabled PCIE Spread Spectrum : Disabled CPU Clock Skew: Auto MB Clock Skew: Auto The Ram is Corsair ddr2-6400 XMS2 CL4 v2.1 (4x1GB) Not too sure what else to say..... it's just a bit frustraiting - any advice would be greatly recieved!!! Cheers Dan
