Hi guys, Just thought I would share with you the wild ride of a week of afternoons putting together a build for Inwin. It was for media event here in Aus, so time was a little tight (when isnt it). Everything i did along the way was out of order. Having to wire the entire build, before putting covers in, and then having the water lines over that meant the process was a little, interesting.... It all began with a covered box and a guessing game First Look inside Finally out of the box Dont get too keen And there she is, wowsers Turns out you can be cheeky with reflections Day 1 light test The Asus core of this build EK Waterblocks <3 Little bit of storage Making sure it runs The real fun begins Test fit 1/304949 The only badge that matters Playing with the colour palette Experimenting with routing 1 Experimenting with routing 2 Playing with different mounting options, sadly this didnt fit More fitment testing Can i fit these here, yes!!! Playing with mounting and clearances, mod required Potential solution MB Tray in place MB tray and midplate in place, begin toying with tubing To cover the midplate or not Prepping for a photo to digitise the pattern on top cover, this will make sense soon Playing with rear cover concept Rear cover test fit Rear cover windowed Rear cover installed Begin detailing Realisation that photos are going to be tough The core shot, almost there Lighting test THE GLAM SHOTS Spoiler Thanks for staying with me til the end, see you on the next project Karma
