Cooling need help with hose/bard/thread change

Discussion in 'Hardware' started by badermans, 8 Apr 2006.

  1. badermans

    badermans What's a Dremel?

    Joined:
    8 Apr 2006
    Posts:
    21
    Likes Received:
    0
    Need a little help

    Basically I'm going water cooling by the end of the month and I have all ½ ID tubing stuff. I haven’t bought the hose yet as I'm away from home for a week. I was thinking of using smaller hose as my case is quite cramped already as I have four HDD and three 5 ¼ bays already in use. I really do not want to modd my case.

    If I do use smaller tubing/hose say 3/8 barbs will there be a massive performance difference.

    The stuff I have so far:

    1/2" TDX Athlon64
    Laing 12V-D5 Pump
    1/2" XSPC R120-D
    Danger Den Single Bay
    Swiftech MCB120 "Radbox"
     
  2. Nexxo

    Nexxo * Prefab Sprout – The King of Rock 'n' Roll

    Joined:
    23 Oct 2001
    Posts:
    34,751
    Likes Received:
    2,255
    You can put 3/8" ID tubing over 1/2" barbs without too much hassle. Just dunk the ends in a mug of hot water for ten seconds or so to temporarily soften the tubing up.

    There will be no appreciable performance difference.
     
Tags:

Share This Page