1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Modding Next best tool to a Dremel? Well in my case, it was a Toaster Oven

Discussion in 'Modding' started by lchyi, 19 Aug 2003.

  1. lchyi

    lchyi What's a Dremel?

    Joined:
    13 Aug 2003
    Posts:
    18
    Likes Received:
    0
    Yea, well, after buying countless number of heatshrink tubing and meshing sleeving, and all sorts of wire connectors. I had a gigantic task on my hands. I had to shrink about 30 different wires. Well, here's what I had in mind to use in the first place: Soldering Iron. Well that sucked, that would have taken forever. Well, I decided to place the iron on the kitchen counter so I wouldn't light the house on fire. Then I saw my old Toastermaster and removed the tray. I turned up the the temp to about 450F and stuck all the individual wire pieces on the tray and stuck it in there. Non-shrunk to shrunk in 2 minutes (including heat up time). 30 pieces done just like that. Whoohoo! Yea, I only used like three tools on this case: dremel, screwdriver, and toasteroven. Sweet.:thumb: :dremel:
     

Share This Page