ok guys well i have been sorting out the garage and my workspace over the last few days soooo here ya go i thought i would share it with you What i started with!!! after a bit of work then after a lot of work and a hellof a lot of sweat!!! (not my best picture i must say!) then we are bassically there just note the boards and bits against the bare wall wont be there that is where the workstations will be! now onto tools and storage pack of 3 bin shelves Heavy duty g clamp Pack of four peg board fretsaw and i have since got a load more tools that i have yet to photograph but i will do so tomorrow. Josh
Ha! That's what you get for wearing a (n appropriately named) "sweat" top, for clearing out workspace
as you can see it got a bit messy in the doorway as i was sorting out the workspace... but here we go.... workstation 1 (drill, belt/disc sander, grinder(with one of the 2 polishing heads on it) workstation 2 beefy new vice(125mm) againts the old 50mm pegboards.... as you can see i had to join the 2 banches together infront of each other as i wasnt happy with the depth but i may still change this my new bin shelves drill that is currently not working lol at the reducer spindle..... unfortunately the polishing kit only came with one spindle so im going to drill the other mop head out a bit to make it fit the normal spindle and thats it so far i have still got to order my bandsaw, tap and die set, and my set of 300 diff hand tools (including screwdrivers, ratchets etc etc) and also if i get my low rate loan/grant thing i will be getting myself a mini cnc mill