Planning Small WC ITX (Lots of Acylic + First Casebuild)

Discussion in 'Modding' started by Fonne, 25 May 2012.

  1. Fonne

    Fonne What's a Dremel?

    Joined:
    9 Oct 2010
    Posts:
    108
    Likes Received:
    2
    Hi

    Have been reading a LONG time on bit-tech but newer really used the forum, so think this is a nice way to start ...

    (Hope my English is ok)

    The casemod is going to be a very small watercooled ITX setup, but right now the money stops me, so the planning is still going on.

    The Hardware im going to use will be something like:

    Asus Z77 ITX
    i7-3770k
    GTX670
    120/128 GB SSD
    - Water on CPU + GPU

    Dont know exactly how to use this "Planning" Thread, but would people like the see some older test that I have done (Engraving Acrylic), different casemods ideas from Autodesk Inventor ?

    Or would it be boring when its not about this mod exactly?

    Regards Fonne (Uploading some different pictures right now)
     
  2. Fonne

    Fonne What's a Dremel?

    Joined:
    9 Oct 2010
    Posts:
    108
    Likes Received:
    2
    Some laser engraving:

    [​IMG]

    A Bench table - Using Autodesk Inventor

    [​IMG]

    [​IMG]

    And Working with CNC :)

    [​IMG]

    [​IMG]
     
  3. Fonne

    Fonne What's a Dremel?

    Joined:
    9 Oct 2010
    Posts:
    108
    Likes Received:
    2
    Any that like acrylic ? :)

    [​IMG]

    [​IMG]

    [​IMG]
     
  4. Fonne

    Fonne What's a Dremel?

    Joined:
    9 Oct 2010
    Posts:
    108
    Likes Received:
    2
    Dont have much time, but right now still looking at colors :)

    [​IMG]

    Some Glitter ...

    [​IMG]

    [​IMG]

    And some Matt finish ...

    [​IMG]

    [​IMG]

    [​IMG]

    [​IMG]
     

Share This Page