So I spent a couple hours working on the platform that supports and/or mounts the SSD, optic drive, and GPU. After inspiration from @Jean R built (thanks again!) I decided to include a track along the side of the platform where I can run my cables for the optic and solid state drive in a cleaner configuration. The optic drive cables will sweep back 180 degrees into the track and the SSD's cables will do a smooth 90 degree bend into the track. I didn't want to make the channel large enough to fit the connectors through so I made a slit along it's length. It is just wide enough to press each cable into the channel and the channel just large enough to fit all the cables (theoretically haha). Now at the back of the case, the sata connectors will run behind the motherboard mount, come out at the motherboard's edge where the connectors are, and plug in there. Nice and clean. The power cables will stay low and run along the side and to the front of the power supply. I like this a lot more as there will not be any of these cables now crossing in open space through the case.