very nice! how did you remove the atx connector though? did you use any special tools? Ive tried with a pin but find it impossible!
I have that mobo sitting in my closet as I type this. I actually ran linux on it for a little while. Good board though. Id like a PCB too.
bsodmike: i'll see what i can do... i have two versions... one is a 2 part PCB and the other is a 4 part... the 4 part is designed to fit perfectly in a box... and the 2 part thing is best to fit behind drive bays... seal: i used a thick needle wich i filed flat (dremel job) then put it down in the hole just between the tab and twisted it... that way the tab automaticly becomes pushed in... It's a bit tricky, but easy whan you figure out the tecnique... [t0rc]: thanks (you'r tag doesn't seem to work here.. ) Fr0z3n: Yeah, it's a nice board.. a bit old thhough.. but hey!, it works!
bubble tubes those bubble tubes came with your case right? they arent your own mod? do the bubbles move? i was looking at doing my own tubes, or panel, very similar to the look of those, but with a pump basically that makes use of lighter and heavier liquids that are heterogeneous (wont combine) my first post on these forums, but with my plans for modding and getting a digi camera these holidays, shouldnt be my last
MrTroy: First of all: welcome to the forums! the bubbles doesn't move... it's solid acrylic rods with bubles. They came with the case. I might make some with moving bubles, but not yet. I don't quite get what you need a PCB for..
Good effort, i especially like what you did with the PSU cables! Will be watching this thread for further updates
thanks Sorry about the lack of updates lately, but i have been busy, besides, i'm going to stuff in some new hardware as soon as i get it.. (damn christmas.. mail and webshops is sloooow!) more updates WILL come... sometime...
i have no idea what that is, but assuming it's a PCB/chematic program i would say no.. sorry... I use "proteus"... i have the files for that...
That'll work. I can't send you an email or a PM, so if you could please send me an email to snarf(AT)planetmars(DOT)co(DOT)za Thanx in advance
dude, very nice job done and awesome attention to detail! i wish i was that creative... well i kinda am i just dont have the resources to put it all to work but all round, job done good. mod on!!
just thought i would make a quick suggestion. Take your old case, get some of that alu, and get at it with a buffer and polish, then, once your done, nice mirror for the bottom of your case (Y) Sorry that was a bit breif, im in a rush
sorry... this project is finished... i have got a new case now... this one is for sale if anyone want it (i might have a buyer already though ) or mabye i should put my "linuxbox" (currently running XP(yeah, i know)) in it?
Nice window!! But a variable speed jigsaw could do that much quicker and easier.. I do use a dremmel where its better - and when cutting a window I stick some thin 6-8mm board to back of case, also important is quality blades ideally not wide so you can change direction easily. But as someone said Laser is best - but not manage to get one yet