Discussion in 'Article Discussion' started by bit-tech, 4 Mar 2019.
Lovely, but not once did you throw a fork at it.
When using tiny end mills, RPM and feedrates are appreciated. -Ironically, I know a guy that uses the tiny bits for his work. His response to to the feed & speed question is, "Eh, whatever I have it set to."
To be fair I think he has a point haha. I used 800mm/min @23krpm for that 0.3mm endmill but it’s nigh on impossible to compare things properly outside of pro-Level machinery. I’ve tried using all the calculations but found there are just too many variables for it to be consistent.
To be honest the crate doesn't do a lot for me, but I loved the video and the custom water cooling work. Nice work on both Alex.
Going to have some stuff on the way that should hopefully be right up your street!
Separate names with a comma.