Modding Heat transfer with lacquer coated rads

Discussion in 'Modding' started by The_Crapman, 20 Jun 2012.

  1. The_Crapman

    The_Crapman World's worst stuntman. Lover of bit-tech

    Joined:
    5 Dec 2011
    Posts:
    8,314
    Likes Received:
    4,647
    I want to strip the paint off some rads to have a bare metal finish on them, but don't want them to dullen over time. If i spray them with a lacquer, will that reduce the heat transfer too much?

    I could ensure i used a very thin lacquer to lessen the effect, but am worried that it will all but stop any heat dissipation from the fins.
     
    Last edited: 20 Jun 2012
  2. barry99705

    barry99705 sudo rm -Rf /

    Joined:
    20 Apr 2008
    Posts:
    810
    Likes Received:
    15
    Probably no worse than the paint that's already on them.
     
  3. The_Crapman

    The_Crapman World's worst stuntman. Lover of bit-tech

    Joined:
    5 Dec 2011
    Posts:
    8,314
    Likes Received:
    4,647
    Good point!
     

Share This Page