Modding Nanoxia Project S Water-Cooling Build: Part Three

Discussion in 'Article Discussion' started by Dogbert666, 22 Nov 2016.

  1. Dogbert666

    Dogbert666 "Kameron?" Staff Administrator

    Joined:
    17 Jan 2010
    Posts:
    1,413
    Likes Received:
    46
  2. The_Crapman

    The_Crapman Don't phone it's just for fun.

    Joined:
    5 Dec 2011
    Posts:
    2,556
    Likes Received:
    85
    Very nice :thumb:
     
  3. Neutronman

    Neutronman New Member

    Joined:
    19 Aug 2016
    Posts:
    17
    Likes Received:
    0
    Looking good. I've just started to put together a shopping list for my next build and this will be my first build with Rigid tubing. I tried acrylic a few years back and just could not get a decent bend.
    Perhaps I'll post my build here after completed.
     
  4. stealth80

    stealth80 Member

    Joined:
    1 Feb 2015
    Posts:
    291
    Likes Received:
    3
    Looks great, apart from one eye sore! Could that 8 pin atx cable not have been routed behind the board ? There's even a cable management hole for it :D
     
  5. Combatus

    Combatus Bit-tech Modding + hardware reviews Staff Super Moderator

    Joined:
    16 Feb 2009
    Posts:
    2,710
    Likes Received:
    47
    There is, but it's completely blocked by the radiator - not even enough room for the cables to thread through!
     
  6. stealth80

    stealth80 Member

    Joined:
    1 Feb 2015
    Posts:
    291
    Likes Received:
    3

    That's a shame, looks great non-the less:thumb:
     
  7. Combatus

    Combatus Bit-tech Modding + hardware reviews Staff Super Moderator

    Joined:
    16 Feb 2009
    Posts:
    2,710
    Likes Received:
    47
    Thanks :) The cable looks much better in person. If I could go back I'd maybe route it under the motherboard but the ModMesh cables probably aren't that flexible. Still it's otherwise a great case.
     
Tags: Add Tags

Share This Page