Radiator to radiator in loop?

Discussion in 'Watercooling' started by Hitman, 1 May 2018.

  1. Hitman

    Hitman Minimodder

    Joined:
    18 Oct 2002
    Posts:
    1,698
    Likes Received:
    29
    I have two 240mm radiators which I was thinking of running in the following order:

    Pump/res > GPU > CPU > 240mm Coolstream SE > 240mm Coolstream XE > back to pump/res.

    Any issues/thoughts on running them in line like this? Trying to workout a nice clean layout for a loop in a Meshify C and this order make it a bit easier to run the pipes, as the block on the GPU exits out of the rear rather than the side.
     
  2. The_Crapman

    The_Crapman World's worst stuntman. Lover of bit-tech

    Joined:
    5 Dec 2011
    Posts:
    8,303
    Likes Received:
    4,644
    That will be fine, the order of the loop doesn't matter and having thembin that order won't affect the temps at all.
     
  3. cobalt6700

    cobalt6700 Minimodder

    Joined:
    17 Oct 2005
    Posts:
    658
    Likes Received:
    134
    As Crapman said - order of the loop doesn’t really matter. So doing it the least restrictive/best looking way is the best way to plumb it. Only order that does matter is res -> pump :thumb:
     
  4. Hitman

    Hitman Minimodder

    Joined:
    18 Oct 2002
    Posts:
    1,698
    Likes Received:
    29
    Nice, I've read as much but never done rad > rad before. That makes thing easier! :grin:
     
  5. cobalt6700

    cobalt6700 Minimodder

    Joined:
    17 Oct 2005
    Posts:
    658
    Likes Received:
    134
    Just think of it as one big rad - not much difference physically :)
     
    Hitman likes this.

Share This Page