Right guys, I had to start the Mod again, with me changing the back distro, it meant all my sizes were out. I started with a simpler design but still has the WOW factor, I think this is just down the the size of the case, I did remove the second loop. I also have to change how I want to mount the panel back to the case, I did want to keep both side panel but I will be removing one of them. Once I made the new back, and sorted the mount for the top panel and side panel, I was happy to start the internals. I started in the basement I recut the bottom panel this is 20 mm from the base of the case I have done this to hide the cables going to the 3 control boxes, which will sit behind the screen you should be able to see these from the right hand side and the top of the case. Once I was happy with this I started with the side panel which will hold the screen, I am using the screen to show celebrate thermaltake product over the last 20 years. You can see I am sticking to the plan I submitted to the competition. These are the cable combs I will be using. I even made some little brackets to hold the mid plate in place, Once I installed the brackets, I added the mid plate which will hold the motherboard, passthroughs and another custom distro plate. I will be keeping the mid plate clear so you can see straight into the basement. I am going to be painting all the parts tonight, bracket for GPU and starting the etching of the glass, I want to have the build completed by friday so all that needs doing is the custom cables and final photos, I am sure they will be a few more updates before then. As always any question please leave below.