I recently installed a Radeon 4350 which I use with an IBM E74 17" CRT (on the DVI port with D-sub converter) as primary display and an HP1502 15"...
Thanks for the suggestion, I tried hibernate which does work but it is slower than standby would be. I would prefer to get standby working if I...
My home built PC will not recover from going into standby. It goes into standby with no problems but when it is woken up the CPU and HDD etc all...
After further testing/fiddling I am sure the problem is a dead graphics card. That being installed stops the on board graphics working. I think...
Help A PC I have had for a few years now has lost video output. The machine uses an old Socket A Gigabyte mobo, an Athlon 2200 and has 1GB of...
Yes it is a Pro version. It is set to 621Mhz on the VPU and 742Mhz on the memory. I think this is a HIS factory overclock
It crashes in games too. The CRT is ok as it has supported these resolutions before. I can force it to 1280x1024 in CCC but only at 60Hz. To be...
Having found out with your assistance that my X1950 is duff I am trying to see if it can be rescued. The card crashes in Furmark after about...
Yes the Gigabyte board is in the clear. As noted before I now have three and the first one is about 6 years old and has served well in two builds.
Got it, I think Following advice on another forum I tested the X1950 with Furmark on the other machine and it would not run more than 90secs....
Hi Trig On the other machine the card was running on 8.476 and later on 9.3. Sadly I don't have another card with a 6 pin feed. I will check...
Separate names with a comma.