A) it is possible
B) yes, all you would have to do is de-solder the crotroller the resolder on the new screen
C) i could make you this...
it seems it is working but no data is being sent to the lcd just have a play with lcdsmartie. have you downloaded any plugins for it ??
are you refering to the ones on page 2 ?? if so they are Mylar Film Capacitors and you can see they are big and bulky
there are no other types used mate
this should help you with your resistor and capacitor values
are these what you are looking for ???
scroll down to near the bottom ( Single Row Sockets )
they are for the lcd's back light (pins 15 + 16 )
pin 15 = + pin 16 = -
pins 8 + 19
VSS = GND
I did not try the back light, I have now and I cant adjust it either. The transistor i used was one I had to hand, if you can get BC184 or the...
you have not soldered the legs of the chip associated with the encoder
If the schematic is right there is no reason
why it should not work. There is a wire link
that you can replace with a track
i suppose but most, if not all only have the 3 pins for the encoder / switches
why dont you download some pcb cad software and make your own.
you could use a 4 Mhz resonator instead of the crystal and the 2 caps
Separate names with a comma.