Not much of an update. But yeah,... I'm getting to the good stuff. I was goign to get some work done in the studio yesterday but I slept all damn day! And it's not like I was even being lazy,... I literally woke up at the end of the day! Time to go to work again! I woke up with the worst headache too Anyways,... I've been thinking and planning, drawing. This update is posted as the 17th but this was like 2 or 3 days ago. I spent the whole night doing one thing,........ trying to figure out how to get the information I need about,... THE BEND. I've done this before too! For the LIFE of me I couldnt think! I eventually got it but damn! It took the whole night! Whats crazy is,... i've done this before! For the HDD front shield, the pump front shields. Whats funny is that I don t remember any of the figures I came up with?!?! Like, I dont know how I did it the last time. I'm pretty sure it was something like how I am going ot do it now but I dont know. I'm going to log all this down for next time. Anyways,... I cant go into great details with this update. But the update where I get started on the PSU shield,... I will. Jul-17-2007 In this pic I have a piece of aluminum clamped with a large peice of angle iron. You all should remember this. Well first, I am trying to determine the EXACT length of aluminum I need to make the center shield. You see, I could easily cut a piece thats way big and then make a bend roughly where I want it and then just size it up and cut off the slack. But then how will I cut out all of the detailed stuff? It wont fit through the scroll saw with that bend. Plus drawing everything out is a lot harder too. I need to do all my drawing and all my cutting etc first on a flat piece and then bend. After bending,... it should fit right in. I dont want to be off no more no less then 1/32"! Making sure it's squared. So important. Now,... how do I explain this, would be easier if I had an illustration. I'll draw something up for you guyz next time. But for now, for 1/16" aluminum to be bent at this radius there are two key measurents you need to pull this off. 1 - 3/64" and if I remember correctly,... 1 - 9-16". 1 - 3/64" is the length from,..... F@#$ this. I'll eplain this later with a pic. LOL. Done. This is what I did the whole damn night! Trial and error. Check it out. MY target height was 2". All three are off by 1/32"! Thats pretty good! There are a few things involved that can throw it off like that. When I go back I will try a few methods to try and make it dead on! The one on the right was bent crooked. I think I had to crooked between the pipes. This is what happens when you dont make sure everything is straight! Goodies! Copper bar! For my PSU bus bar! I'm goign ot cut them in half long ways because they dont need to be that wide. Screw insulators! So I dont send a massive jolt through out the case! Frying everything! WhaHOOOOOO! 200, 1/4" nylon spacers! 200, 1/8" nylon spacers! YAY! 200, 6-32[M3.5] thread-serts! Large O-rings! NOT going to tell you what they are for! So,... this is not the only thing I have been planning too. You're going to have to go to my Case Evolution log to find out,... peace.