Case Mod - In Progress Tribal's case - Christmas update hehehehe 13/12/2007

fastening the hinges of the door:


as it will be, it is very well hidden.


I will use those buttons with magnet used in bags: D the door is well locked.


fastening one of the parts in front of the case. and making some adjustments


fastening the magnet in the door of the case, I glued him with acrylic:

 

open door and fastened:


closed door and fastened:

 

Thats some damn good molding work going on there, I think the skulls turned out just as good as the original

 

that is some amazing work you have done there. 5* from me.

 

ledbythereaper, thank you for the comment, the skull was beautiful same (modest me hehehehe)

500mph, thank you for the 5 *, I am happy that you have liked my work

 

I set up the case for seeing how it would be, but I noticed an unevenness between the front and the foot, then I put a piece of acrylic of 3mm to compensate this. after cutting I had to do some adjustments with acrylic resin to fit perfectly.



everything finished and sanded, the holes of VUs also done already.



I didn't like holes as they were, then I decided to tilt the angles, the result was good, taking into account that I made everything only with the dremel:



Test with VUs in the places:

 

Is it me or is the second hole along smaller than the others?

Looking very good so far mate!

 

you are right, the second hole is smaller because there it goes is the place the power button, that will also be personalized. the first hole and for VU of HDD. thank you for the comment



some pictures of the front general vision:

 

Thread closed as per OP's request.