Scratch Build – In Progress [Project] Modularis Evolution... updated alot!!! nearing completion!

Very nice design !
and the build quality is realy amayzing !!
but the design kinda reminds me of dutchcedar's casemod.

keep up the good work !!

 

Thanks dark

and it was inspired by cedar but in no way copied and very very different

 

Ok guys well i tried out drilling the holes through the support and it worked out quite well but i noticed if you drill all the way through you will chip the side that the drill comes through whereas if you drill most the way through so that the drill is just poking through then turn over and drill the other way you dont chip it.






I then decided to move on to the next module.... so here goes

step by step :

1. i mark out the piece that will be bent


2. then cut it out


3. then grab your 30"bending brake


4. mark where you want it bent


5. start bending untill you think its about right


6. grab your set square with a handy 45degree angle on it


7. check angle its not quite right just bend some more and if its too bent then just push it back with your hand.


8. repeat stages 4-7


and that is it for today guys.

hope you enjoyed it

Josh

 

Hmm, what's that?

 

It is the starting of the psu housing (the right hand lower module)

 

Nice designs, nice execution!

 

i like the work with perspex - toxic green with black is one of my favourite color schemes Good Job so far! I will be watching this one for sure!

 

Oh ok i see, it's gonna be great (Do i even need to say that? lol)

 

Thanks guys its great to hear people are liking my mod

 

The layered look rules.
You say you had trouble with the tile saw? Was it the plastic protective layer, or water in the face syndrome?
It looks like a little water could help your drilling too. Either that or the wood under the material was too soft.

When I asked about 'gaps' I meant 'seams.' I was kinda sleepy. My punctuation and vocabulary goes away when I'm sleepy.

 

Liking's a bit of an understatement from the looks of it

well, from me, definitely

 

Thanks guys

and cheap it just wouldnt cut straight i ran it along the fence but then as soon as the first part got past the saw it started to go off to the right...

and i did use water with the drilling. but i dont mind about the drilling thats easy enough to sort.

Josh

 

Dude You are doing a KICKASS job here. I Don't know how I didn't tell you that from long time but it rocks, Keep Us updated. ROCK ON!

 

Lol thanks ck there will be an update tomorrow night aswell

 

ok guys time for another update!!!

ok the rest of the psu housing has been bent!


and the side bent


And on the side


And now just a quick mock up using parcel tape to show you lovely people how this is going together

Its pretty big!


Hdd housing alu marked out


And bent and joined


and put on top of the psu housing to show how it goes



I hope you enjoyed it and tune in tomorrow

Josh

 

Looking good

But how are you going to drill the holes in there for the cables to fit if the HDD housing is fully built?
Unless it's not fully built and I'm a dipstick for not noticing?

 

Hot Hot hot. Good job my buddy. I hope you end this project before world end

 

Lol ck!! it wont take too long to complete :up:

And bigsharn all i have to do is cut a hole in one of the sides for the cables its not too hard... and its not completed yet just bent to the right shape

Josh

 

going on nice ^^

 

thankyou